Request a Quote (407) 706-5650

Aircraft detailing

Exterior Aircraft Washing in Orlando

A proper exterior wash removes what Florida puts on an aircraft every week — bugs, exhaust, pollen, lake-air film and red Apopka dust — without putting water or chemistry where it doesn't belong.

Washing an aircraft is mostly about restraint. The fuselage, wings, control surfaces and empennage are cleaned by hand with wash chemistry chosen for painted aluminum and composite, using dedicated mitts and towels so grit picked up from the belly never touches the upper surfaces. Before any water is used, we identify and protect the openings: static ports, pitot tubes, fuel vents, drains, cabin air inlets, antennas and any probe or sensor specific to the type. Pressure washing is never aimed at seams, bearings, hinges, cowl gaps or avionics bays.

Owners choose between a wet wash (soap, controlled water, full rinse and towel dry) and a waterless or low-water wash for hangared aircraft that are lightly soiled. The right choice depends on how dirty the aircraft is, where it's parked and whether your hangar permits water on the floor. We'll recommend one when you request a quote.

This is cosmetic care only. We do not remove inspection panels, cowlings or fairings, and we don't service, lubricate or adjust anything. If we see something that looks like it needs a mechanic — a weeping fuel drain, a cracked fairing, a loose fastener — it goes on your completion report.

Technician hand-washing the wing of a Cessna 182 inside Hangar 56

What's included

  • Pre-wash walk-around and photo record of existing condition
  • Identification and protection of static ports, pitot tube, vents, drains and sensors
  • Two-stage hand wash of fuselage, wings, empennage and control surfaces
  • Bug and light residue removal from leading edges, windscreen frame and cowl
  • Belly and exhaust-track cleaning with a dedicated degreaser safe for the finish
  • Landing gear, wheel pants and fairings
  • Exterior windows cleaned with an acrylic-safe cleaner and clean microfiber
  • Towel dry, water-spot check and removal of protective covers
  • Completion report with notes for your mechanic if anything was observed

How the service runs

  1. Walk-around and condition photos

  2. Protect openings, probes and sensors

  3. Belly and exhaust areas first, with dedicated materials

  4. Upper surfaces, wings and tail, panel by panel

  5. Rinse or wipe-down, then dry

  6. Windows last, with acrylic-safe product

  7. Remove protection, final inspection, report

Benefits to the owner

  • Removes contaminants that etch paint and attack bare metal if left through a Florida summer
  • Makes pre-flight inspection easier — cracks, hangar rash and leaks are visible on a clean airplane
  • Keeps a coated or polished finish performing the way it should
  • Lets you see the aircraft the way a buyer or passenger does

Suitable aircraft

  • Single-engine piston: Cessna 172/182/206, Piper Cherokee/Archer/Saratoga, Cirrus SR20/SR22, Beechcraft Bonanza, Mooney M20, Diamond DA40
  • Light twins: Baron, Seneca, DA42, Aztec
  • Turboprops and light jets by arrangement
  • Experimental and light sport aircraft, with owner guidance on any unusual materials

Limitations and compatibility

  • Fabric-covered aircraft and bare-polished aluminum need a different approach — tell us in advance
  • Exterior washing does not restore oxidized paint; that's paint correction
  • We follow the manufacturer's care guidance where published; some types restrict water near specific areas
  • Ramp washing at other airports depends on that airport's rules and wash-water requirements

When to schedule

Hangared aircraft that fly a few times a month do well on a wash every 4–6 weeks; aircraft on tie-downs or flying weekly in Florida summer benefit from every 2–4 weeks. Love bug season (roughly May and September) and after any coastal trip are the times not to wait.

Further reading

Related

Full Aircraft Detailing

A related service, scoped the same way.

Bug & Exhaust Residue Removal

A related service, scoped the same way.

Aircraft care plans

Keep the result with a recurring program.

Orlando–Apopka Airport (X04)

Where we're based, and how service works here.

Questions aircraft owners ask

Do you pressure wash aircraft?

Not in the way a car wash does. Low-pressure rinsing is used on open surfaces only; nothing is sprayed at seams, hinges, bearings, cowl openings or avionics areas. Static ports and the pitot tube are covered before any water is used.

Wet wash or waterless — which is better?

Both have a place. A wet wash is the right answer for a genuinely dirty aircraft or one that's been on a tie-down. A waterless wash is efficient for a lightly soiled hangared aircraft and avoids water on the hangar floor. See our article on wet wash vs. waterless cleaning.

Can you wash at my hangar instead of Hangar 56?

Often yes, depending on the airport and your hangar's water and drainage situation. Tell us where the aircraft lives when you request a quote and we'll confirm.

Will you clean the windows?

Yes — with a cleaner formulated for acrylic and clean microfiber, never paper towels or ammonia-based glass cleaners.

Ready for a flight-ready finish?

Tell us about your aircraft and we'll come back with a scope, a schedule and a quote — one-time or recurring.