Request a Quote (407) 706-5650

Aircraft detailing

Aircraft Brightwork Polishing

Bare aluminum, stainless and chrome are what make a classic airplane look like a classic airplane — and what dull first in humid air. Brightwork is the patient, cosmetic polishing of the metal surfaces that are ours to polish.

Brightwork covers the eligible bare-metal surfaces on an aircraft: spinners, wing-root and tail trim, exhaust tips and shrouds, stainless screws and latches, steps, and on some aircraft an entire polished-aluminum airframe. The process is progressively finer metal polishes applied with the right pads and plenty of time, then a protective sealant that slows the dulling Florida humidity causes.

The cautions matter more here than anywhere else. Polishing removes a microscopic layer of metal, so we never polish structural fasteners or anything where the manufacturer's guidance restricts it, and we stop at the edge of anything that isn't cosmetic: propeller blades (polished only as surface cleaning, never as blade work), pitot tubes, probes, antennas, hinges, bearings, control surface balance weights and placards. Alclad surfaces are treated with particular restraint because the protective pure-aluminum layer is thin.

Whole-airframe polishing is a multi-day project quoted after an inspection.

Mirror-polished propeller spinner on a vintage aircraft

What's included

  • Inspection of all bare-metal surfaces and identification of anything excluded
  • Washing and chemical decontamination of the metal
  • Progressive polishing with aluminum- or stainless-specific compounds
  • Hand work around fasteners, seams and edges
  • Residue removal and panel wipe
  • Metal sealant to slow re-oxidation
  • Report listing surfaces polished and surfaces deliberately excluded

How the service runs

  1. Inspect and mark exclusions

  2. Wash and decontaminate

  3. Coarse-to-fine polishing stages

  4. Hand finishing

  5. Clean residue

  6. Seal

  7. Report

Benefits to the owner

  • Restores the mirror finish on spinners and trim
  • Removes water spotting and haze from stainless and chrome
  • Sealed metal stays bright longer in humidity
  • The single biggest visual upgrade on a vintage or polished-aluminum aircraft

Suitable aircraft

  • Any GA aircraft with bare-metal trim, spinners or exhaust tips
  • Polished-aluminum airframes: vintage Cessna, Beechcraft, Luscombe, Ercoupe, Globe Swift, RVs and similar — quoted after inspection

Limitations and compatibility

  • Propeller blades are cleaned on the surface only; blade dressing or polishing is propeller shop work
  • No polishing of structural fasteners, probes, pitot tubes, hinges or anything restricted by the manufacturer
  • Pitting, deep corrosion and scratches through Alclad are not corrected cosmetically and are referred
  • Anodized and clear-coated metal are cleaned, not polished

When to schedule

Before shows, photo shoots and sales; annually on hangared aircraft; more often for aircraft stored outdoors or near the coast.

Further reading

Related

Aircraft Polishing

A related service, scoped the same way.

Full Aircraft Detailing

A related service, scoped the same way.

Aircraft care plans

Keep the result with a recurring program.

Orlando–Apopka Airport (X04)

Where we're based, and how service works here.

Questions aircraft owners ask

Can you polish my propeller?

We clean and brighten the exterior surface. Anything that removes material from a propeller blade is propeller-shop work and we don't do it.

How long does a polished-aluminum airframe take?

Days, not hours, and it depends on condition. We inspect first and quote the project in writing.

Will the shine last?

Longer with a metal sealant and regular washing, but bare aluminum always dulls again in Florida. Many owners put brightwork on an annual cadence within a care plan.

Ready for a flight-ready finish?

Tell us about your aircraft and we'll come back with a scope, a schedule and a quote — one-time or recurring.